stiefbeen22 The unit comes with a bushing to mount the endmill. I made another bushing with a mounting hole for a 4 mm endmill. I did not (yet) buy an ER set because of its height, and perhaps its runout.

stiefbeen22 This depends on the length of your endmill, the position of the motor in its mount and the Z-travel you need. But in my case I have a 35 mm in thick piece of PVC mounted now. I did order a 20x20 extrusion in order to be able to enlarge the Z-height for longer endmills. The Z-travel remains the same of course.

stiefbeen22 No, I don't think it is, there is no 1 connector that connects the screen to the body. Of course things could be taken apart, but it certainly is not meant to be. Thus the screen is not repositionable.

stiefbeen22 The size is 1 DIN. The side of the radio has cooling ribs and the middle ones can perfectly be used to slide over strips (9x6 mm) you can mount on normal side mounts.

stiefbeen22 I am not familiar with that car. I built this unit in a Chevy Spark 2010. I had to fabricate the 1 DIN mount as well as adjust a 7 inch facia. It works OK, My review gives more details on the features, The key-1 and 2 wires for the steering wheel control are doable. I will explain that at another moment in time. Sorry to not be more accurate for your specific car. Rob