Alle Nachrichten

Q: dji googles are compatibloe with this vtx?

gefragt von rjrsousa auf 2021-09-17 09:00:05

BartR no. This is analog VTX. You can add analog RX module to DJI goggles and be able to receive signal from this VTX but otherwise it is impossible.

2021-09-17 10:41:53 Hilfreich (0)
Vorlegen
Antworten (5)

Q: is this series or parallel?

gefragt von ollie2612 auf 2021-07-04 06:08:10

BartR series. gives 2s 18650 pack - thus 7.4v in descr.

2021-07-05 03:13:30 Hilfreich (1)
Vorlegen
Antworten (7)

Q: can i use caddx nebula nano on the 5inch version?

gefragt von DJEusebio auf 2021-04-28 02:42:37

BartR nebula nano is 14mm wide. Mount is for micro sized cameras so 19mm. Should work with adapter form anno to micro size. If you plan to use it with vista on back mounting place 8cm cable will be to short, 12cm should be barely enough but cable might be strained. I've used 20cm replacement cable with nebula pro and vista - it's way to much and I have to hide excess cable in frame but I'm not worried cable will pull plug form vista or camera on crash. This applies to non HD version. HD one should fir dji cam so 20mm mount + maybe they moved mounting point closer - not sure though.

2021-06-10 02:49:49 Hilfreich (0)
Vorlegen
Antworten (2)

Q: Are the props in the camera view?

gefragt von merlin.boehm auf 2021-06-10 01:47:54

BartR yes. not much but they are visible - at least for nebula pro. For hd cam mounted on top - this depends on camera and mounting. I use insta360 go2 with my custom mount and they are visible only on some rapid motions where image stabilization reaches edges of camera FOV - in normal cruising they are not visible.

2021-06-10 02:37:45 Hilfreich (1)
Vorlegen
Antworten (4)

Q: Passt die caddx tarsier?

gefragt von Samseazy auf 2021-05-10 03:36:45

BartR Hardly. Tarsier 2 lenses are too tall but could be mounted if distance tubes willl be removed. Also Tarsier cable is to short for mounting in on back 20x20 mounting spot. Maybe stacked on top of aio could work but this would be tight fit

2021-05-14 04:00:23 Hilfreich (0)
Vorlegen
Antworten (2)

BartR according to matek itself: "INAV2.5 ublox, ublox7, NMEA all don’t support NEO-M9N. M9N is supported by INAV2.6 ublox or ublox7 protocol(both run at 5Hz)"

2021-05-13 05:21:07 Hilfreich (0)
Vorlegen
Antworten (1)