BG241213633 While it’s not really waterproof it’s easy to do. I waterproof every servo, receiver, esc as well as other electronics like multi meter that I may use outdoors with Silicone Conformal Compound. Just remove the 4 screws on servo, pull on the bottom &either dip it or brush both sides with the Conformal compound, let it dry and screw it back together. It goes on clear & u can use 1 or more coats. I highly recommend silicone conformal over acrylic. The acrylic works as well but can flake if scratched. No such worries with the silicone conformal compound as it remains flexible. It’s what all the electronic oem manufacturers use to waterproof there electronics

BG241213633 No, not as is, but you could modify the motor mount easily by drilling a couple holes. Or you’d need to make one of the holes on the current mount into a slot so that you could move the motor closer to have contact between the pinion gear & spur gear

BG241213633 Will fit fine. As mentioned in previous post, if you currently have a brushed motor set up with 5wire servo receiver then you will also need a brushless esc, 3wire servo, & transmitter & 3wire receiver

BG241213633 YES! It fits. Aside from the decals the124016 & 124018 are same rc, 016 has brushless motor, 018 has brushed motor. Same as the 134017 & 124019 are the same rc with the 017 having brushless motor and the 019 having a brushed motor. Make sure u open this up and properly shim it and grease it

BG241213633 Yes. Fits 144001, 120418, and 124019. All the same rc’s and all use same parts. Only difference is the 144001 is slightly shorter chassis.

BG241213633 Are you asking if this will work with water cooling heatsinks for an rc boat? Any 24mm coiled motor heat sink will work for water cooling

BG241213633 Yes and no! At 8.4v then yes. Anything less then no. Most esc outputs 6v or less on BEC. A few higher end esc has adjustable BEC that does 7.4v & only a handful goes higher. If u connect this directly to a 2s battery u will get the full listed rpm but will taper off as your battery drains.

BG241213633 Yes this will work. I have to disagree with the other poster though. While both the “red” and the “blue” servos are both excellent choices for budget servos, they both fall rather short on the stated specs. I have thoroughly tested and head-to-head compared the two I have found the ones I recommend most are this very “blue” SPT 35kg for 1:10 monster trucks, the “red” 3218 for 1:10 2wd sct (slightly faster but significantly less power on testing and the “red 3218 pro for 1:10 2wd buggies. Testing shows a greater variance with the red servos. On a 25kg servo one throw may register 20kg and the very next 14kg. The blue servos seem more consistent. If you are using larger heavier tires on 1:10 monster trucks such as JC concepts throwbacks then this 35kg isn’t close to being powerful enough. But for the stampede or rustler 2wd or 4wd with oem sized tires this is perfect