Deltaking itcould but your print area would be much less pending which CR10s version

Deltaking yes

Deltaking 1.75mm

Deltaking Thedevice has extra ports so If you know our firmware well you could add one but would most likely void the warranty as it is a modification you will need to apply to the device

Deltaking Itworks well with ABS but using a device like this for ABS it would be best printing during a warm day without the enclosure. If you want to print ABS well an enclosure would be the best bet

Deltaking I found that pushing anywhere above 90 deg on the bed temp the magnet separates from the build track after a while. If you plan to continually print with the heated bed above this temp i would recommend looking at an alternative. (no details on what type of magnet it is but does not seem to lose its charge)

Deltaking It will work on any FDM printer with a bed size of 235mm x 235mm or smaller (as long as it doesn't intercept moving parts)

Deltaking Itworks well with ABS but when you start to exceed 90 deg on the bed the build track starts to separate from the magnetic bottom