RCAirplaneDude The kit does NOT come with electronics. You will need to purchase that. The kit is for someone that already have electronics or for someone that wants to install specific electronics.

RCAirplaneDude Copter123 do you have the mods done for the brushless motor on video or pictures? i would like to see how its done. This motor says it can handle up to 6s. will it work with 4s? i tried uaing 4s on the stock motor and it fried.

RCAirplaneDude Make sure you have the virtual.comm port software installed and also make sure you use a usb data cable you know is working. That should be your first step.

RCAirplaneDude If you use a 4s on this motor, it will burn out after a few seconds at high throttle. 3s is best. I know because i tried it and now i am buying a replacement:-(

RCAirplaneDude This product has a channel auto search capability and if your copter is transmitting at 5.8 Gz it is most likely able to pick up the channel. Check the specifications of the Tinyhawk to verify the bands used there and with the bands that are used on this device. Most likely it will work. Hope this helps.

RCAirplaneDude Its hard to measure but from one end of where the tire to the middle it's 6.5 inches or 165.1 mm. However, it's about 11 inches or 279.4 mm across. Hope this helps.

RCAirplaneDude Make sure that you have Betaflight configured so that the port in you FC is set to serial or UART being used is set to serial. Also make sure that the Protocol Provider is set to SBUS. Connect 3 wires from Receiver to 3 wires from FC on UART 2 or SBUS pads. Hope this helps. Also before i go, make sure you are using the SBUS connector on the FS-A8s receiver.

RCAirplaneDude thistransmitter has an Internal Multi-protocol RF System which can bind to many receivers in the market today. It may be compatible with kyosho. Check with the radiomaster specs on their website or contact their support for further information. So far every transmitter i have has bound and it works great !!