ShadeyB 220x220x250mm 220 length and width with 250 height

ShadeyB It’s a spare 0.4 nozzle

ShadeyB Come’s with 0.4mm nozzle which are standard for printer. Pack of 25 replacement nozzles can be bought for £6 or less

ShadeyB This works fine without any upgrades, I would suggest upgrading the bed levelling springs, this reduces the amount of times you need to level the print bed

ShadeyB Cwclockwise direction or ccw counter clockwise, I choose depending on directional spin on motor or if building twin engine be sure to have both to cancel out torque roll

ShadeyB Yes to all your outputs, from Tx to Rx then into the A3 gyro which is linked to your control surfaces

ShadeyB Yeahthis just transfers your TX-RX signals to the control surfaces with additional stabilisation input

ShadeyB Yesit should be fine, your radio and receiver deals with your inputs , these are passed to the gyro which activates your control surfaces with stabilisation