Kundenbewertungen

4.93 aus 5
Eine Bewertung schreiben
  • Alle Bewertungen (84)
  • Image (2)
  • Video (1)
  • All Star
    • All Star(84)
    • 5 Star(78)
    • 4 Star(6)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sortiere durch:
Zur Vorschau
  • Zur Vorschau
  • Am hilfreichsten
  • Die letzten
Bewertungen nur aus Ihrem Land (Germany)
  • April-24 2018 05:29:37

    For higher temperatures I will definitely use higher quality probe, but it will use a purpose for now I guess.

    Kommentar
  • June-23 2016 08:28:05

    I tested on my soldering iron and on room temperature. On soldering iron it is about 5°C off, but I am not sure whether soldering iron is accurate too. On room temperature, it is off by 2°C or less. Thanks.

    Kommentar
  • July-21 2020 08:43:02

    All good. Banggood !

    Kommentar
  • July-06 2020 10:10:09

    Arrivato funzionante :)

    Kommentar
  • June-17 2020 06:16:00

    quality product

    Kommentar
  • January-30 2016 11:25:51

    I have received 3 sensors, and set them up to compare to my Lab reference PT100. Found differences in resistance about 2.4 Ohms. And this translates to about 8 deg. of C - shift to the lower temperature. If using this sensor "as is" measured temperature of 21 deg. of C will be seen as 13 deg of C. (This problem also was reported by: tioted in 2015-07-29) To correct the problem, I have connected 2.4 Ohm 1% Metal Film resistor in series with the sensor. This corrected the problem but introduced some

    Kommentar
  • March-27 2015 10:21:48

    After I calibrate & linearize the critical band of temperatures, I use this sensors and runs fine. After 12 days of running the results were good for variation & accuracy,

    Kommentar (1)
  • October-24 2015 15:04:29

    Sonde con rapporto qualita' prezzo molto buono , precisione non eccellente, costruzione e ingombro buona...con tutti i limite delle pt100 a due fili.

    Kommentar
  • June-21 2019 07:28:27

    Reliable and well insulated temperature sensor. with its relatively small diameter fit even 2 sensors in a normal dip tube. So you can evaluate and process the same measurement at two different locations.

    Kommentar
  • July-10 2016 02:40:49

    Well produced PT100 temperature sensors. A ADC is needed to get readings on the computer but there are many solutions to be found. A small Arduino board or a DS2450 ADC for a 1-wire set up will do the trick.

    Kommentar
Show:

    Total 0 pages

    Go to page

    Go

    Sie interessieren sich vielleicht für:

    recommendation for you
    • 16,50€
    • 18,15€
    • 33,02€
    • 49,53€
    • 8,25€
    • 14,85€
    • 5,77€
    • 9,90€
    • 12,38€
    • 15,30€
    • 11,55€
    • 33,02€
    • 125,48€
    • 12,13€
    • 25,58€
    • 11,37€
    • 13,20€
    • 34,88€