eric.brasseur
Q: That's not an mmcx antenna you are refering in specs,thats a UFL
gefragt von PoLLaR auf 2023-12-11 03:12:43
guglielmon goin the osd menu, video format
2023-07-21 07:23:45 Hilfreich (0)
Q: Do the goggles display in 4:3 or 16:9 format? Can they do both?
gefragt von eric.brasseur auf 2021-09-09 03:53:57
dd59 4.3
2022-01-17 05:39:50 Hilfreich (0)Q: Does it fit the Eachine E013
gefragt von BG142210321 auf 2022-01-03 07:10:14
eric.brasseur No. Their size and shaft diameter are way too big. For the Eachine E013, you need propellers with a shaft diameter of 0.8 mm and a propeller diameter of 31mm.
2022-01-03 08:54:41 Hilfreich (1)
eric.brasseur They will fit the diameter of the shaft of the motor and they should allow flight but they do not necessarily fit the drone, because they are intended for a slightly more powerful motor type. The motors of the Eachine E009 will heat more, and so on.
2021-11-15 01:37:01 Hilfreich (1)Q: will those fit on the Eachine QX65 ?
gefragt von davicoradini auf 2021-10-30 04:55:48
eric.brasseur Yes. The Eachine QX65 uses 615 coreless motors and 31mm propellers, so these propellers will fit. Having four blades instead of the QX65 standard propellers three blades, they should provide more traction but the motors will heat more and the flight would be shorter. It's worth trying out if it will fly and if you like the change. Check the motor temperature... Maybe also try out propellers with only two blades.
2021-10-31 01:30:38 Hilfreich (1)Q: Only 15 cm. If I would like to have a 30 cm Long Wire it it's possible?
gefragt von BG545522118 auf 2021-10-19 10:44:09
eric.brasseur I couldn't find any for sale. Maybe buy a length of that thin coaxial cable and carve the antenna out of it. Type "buy rf113 cable" in a search engine. But take into account that you have a signal loss over long lengths of cable. Maybe you better move the RF circuits closer to the antenna and keep the antenna cable short.
2021-10-20 02:40:24 Hilfreich (0)
Q: what is the kv of this motor?
gefragt von BG010642142 auf 2021-08-02 08:09:58
eric.brasseur This motor is rated at 3.7 Volts DC. According to the data, its rotation speed with no load is 53500 rpm. So, 53500 divided by 3.7 being 14459, its motor velocity constant Kv is about 14460 rpm per V.
2021-08-03 03:14:57 Hilfreich (0)Q: will these fit the Flywoo Hex Nano?
gefragt von Sam0007 auf 2021-07-20 06:17:36
eric.brasseur Yes, provided that you order propellers with a 1.5mm shaft.
2021-07-22 01:40:10 Hilfreich (0)Q: What voltage do these run on? (will a 3-5v arduino output fry them?)
gefragt von BG163918513 auf 2021-06-17 12:28:50
eric.brasseur They are for drones with 1S batteries, meaning that they take voltages from 4V down to about 3V and a little below, modulated by a switching power supply. Yet they can burn even if fed a voltage in that range, if the mechanical load is too high, the worst being if the motor is simply blocked. If you feed them a voltage between 3V and 5V through a power silicium diode or two in series (that will each subtract 0.7V) and the load is a little propeller, there should be no problem. Check the temperature of the motor... On the other hand, if the motor is fed 5V directly and is connected to a gearbox that can stall and blockade, then it's a matter of seconds for the motor to fry. Maybe you can protect the motor by adding a power resistor in series. Also take into account that these motors can draw high currents, so they can actually also be a danger for the power supply. They are highly efficient and produce a tremendous amount of mechanical power compared to their small size and weight but with great power comes the need to be handled with respect.
2021-06-17 01:21:48 Hilfreich (0)
eric.brasseur XK110 helicopter uses the white plug. PH2.0 plug and white plug are very different. They are incompatible. White plug is flat and is reputed to be unreliable. PH2.0 is more box-shaped, it is reliable and allows for high current.
2021-05-31 08:09:48 Hilfreich (0)Q: What is the size of this battery?
gefragt von BG443832512 auf 2021-05-23 08:30:42
eric.brasseur Caliper says a length of 60mm, width of 17mm and thickness of 6mm. Close to the plug, the thickness is slightly more; about 6.5mm. Wire length is short, about 11mm.
2021-05-23 12:05:34 Hilfreich (0)
Wir laden Sie herzlich ein, die E-Mail mit der Einladung zur Antwort zu abonnieren!
Wenn Sie sich anmelden, werden wir Sie per E-Mail einladen, um Fragen zu Produkten zu beantworten. Wenn Sie sich anmelden, erhalten Sie auch das "Hilfreiche Abzeichen"! Sie können sich jederzeit auf der Seite mit den Datenschutzeinstellungen abmelden.
Helfen Sie anderen und seien Sie glücklicher!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
eric.brasseur Regular VTX that have IPEX connectors, actually have IPEX1 connectors. This VTX has an IPEX4 connector. You can buy a short cable to convert IPEX4 to IPEX1.
2024-03-23 05:33:25 Hilfreich (0)