Alle Nachrichten

Franck_HELIE With betaflight, if you use sbus connected to rx6, you probably don't need ppm 1 pin. In this case, you can use softseral_tx on ppm 1. To do that, in btf cli, write following commands : activate Telemetry & softserial in btf configuration resource PPM 1 none resource ESCSERIAL 1 none resource PWM 1 none save resource SERIAL_TX 11 B08 save set tlm_inverted = OFF set tlm_halfduplex = ON save that's all, you will now be able to receive telemetry on your taranis ... (tested on board flashed with betaflight omnibusf4sd firmware 3.5.4 & X8R rx)

2019-01-17 03:57:32 Hilfreich (1)
Vorlegen
Antworten (3)