Alle Nachrichten

Richard B is loop C is hook When you add to cart and select B or C , the picture changes and the word hook and loop is shown as appropriate.

2022-09-12 07:02:36 Hilfreich (0)
Vorlegen
Antworten (1)

Q: What is the wattage of the amplifier? can be connected to car speakers?

gefragt von BG451823504 auf 2021-07-19 07:13:25

Richard It only has signal level output. It can be connected to an amplifier which can be connected to car speakers.

2022-08-23 12:06:34 Hilfreich (0)
Vorlegen
Antworten (6)

Q: Cannot bind to my JR DSM-2 transmitter. Suggestions?

gefragt von BG133716492 auf 2020-10-06 12:35:42

Richard The required protocol is V761, not DSM. V761 is available in 4in1 multiprotocol modules, as found in many but not all OpenTX transmitters. An example is the Jumper T12 Pro.

2022-01-14 07:21:59 Hilfreich (0)
Vorlegen
Antworten (2)

Q: Hi guys ! Is it possible to bind it why a 2.4Ghz transmitter ? Thanks

gefragt von BG184844324 auf 2020-05-04 01:32:24

Richard It will bind to OpenTX transmitters like the Jumper T12 Pro. Suitable transmitters must have a 4in1 multiprotocol module. A single multiprotocol module is not sufficient because the V761 protocol is not supported by the chip used in single chip multiprotocol modules.

2022-01-14 07:18:12 Hilfreich (0)
Vorlegen
Antworten (2)

Richard The V761-1 model uses a 160mAh battery and flies for about 10 minutes. So the battery capacity is one sixth of an Amp-hour and the flight time is one sixth of an hour. This reflects an average current of 1 Amp.

2022-01-14 07:14:32 Hilfreich (0)
Vorlegen
Antworten (2)

Richard It will bind with OpenTX transmitters that have a 4 in 1 multiprotocol module. It is not sufficient to have a single multiprotocol module.

2022-01-14 07:09:23 Hilfreich (0)
Vorlegen
Antworten (2)

Richard RO = Reverse Osmosis. Very very pure water.

2021-12-11 11:55:14 Hilfreich (0)
Vorlegen
Antworten (3)

Q: Can be bind with Jumper T12 ?

gefragt von popad auf 2021-02-06 10:41:17

Richard I bind them to a Jumper T12 Pro transmitter, which has an inbuilt 4-in1 Multi-protocol module. With a T12 (not Pro) I think you have to put a 4-in-1 module into the bay on the back of the TX.

2021-10-15 08:35:24 Hilfreich (0)
Vorlegen
Antworten (2)

Richard I use them with a Mode 1 Jumper T12 Pro transmitter. That's how I got around there not being mode 1 versions of the OEM transmitters.

2021-10-15 08:30:57 Hilfreich (0)
Vorlegen
Antworten (2)

Richard@BOOGIE V761protocol for Volantex and Eachine. Then 4 channel sub-option. For gyro control configure 3 position switch on CH5 with settings of -100%, 0% and 100%

BG015251038 18/11/2020
3
Kommentar (6)