4.79 aus 5
Eine Bewertung schreiben
  • Alle Bewertungen (43)
  • Image (5)
  • Video (0)
  • All Star
    • All Star(43)
    • 5 Star(36)
    • 4 Star(6)
    • 3 Star(0)
    • 2 Star(1)
    • 1 Star(0)
Sortiere durch:
Zur Vorschau
  • Zur Vorschau
  • Am hilfreichsten
  • Die letzten
  • May-28 2020 20:15:11

    Bonjour, Pour commencer, l'article livré pourra avoir une apparence différente comme tel a été le cas pour le mien mais cela n'influe en rien sa qualité (Voir photo). L'accroche magnétique est excellente et ne diminue pas vraiment malgré une chauffe intensive du plateau (100°C pour l'ABS). Aucun soucis pour décoller un print quelques minutes après qu'il soit terminé. Restera à voir la durée de vie de la surface lors d'une utilisation relativement soutenue. L'installation prend quelques

  • January-10 2020 04:06:25

    is small for cr10s pro

  • May-04 2019 13:05:32

    Description says usable up to 80°, but in facts, only up to 70° like you could see on the pic. Can't be used for nylon or abs.

  • March-29 2019 05:01:26

    für 20x20 super aber nicht für 30x30

  • March-25 2019 14:37:52

    Why would you ship it in a bag with my pulleys and bearings?? There is a large dent in the middle of the surface from being squished into the pulleys. Then the edges have large dents, not to mention one side being folded over. I dont think I'll even use this now as my prints which always start in the center are not going to be flat. I am sure I would have given 5 stars had this been protected some what during shipping.

  • February-13 2020 15:03:55

    smels like hot plastic at 80C. Also hard to remove petg from it at this temp. Works good for 60C, light smell, so far not bothering me. Meted a bit when I homed the printer and kept nozzle close to bed for about 2 min.

  • November-30 2020 08:53:00

    está bien pero el iman tiene muchas burbujas de aire y tienes que pincharlas para que te pueda imprimir bien

  • StigN
    September-22 2020 14:49:12

    Great functionality, however it was a little shorter than expected. does not fill the bed of CR10 S Pro V2.

  • June-12 2020 16:56:04

    this time the flexible is delivered in flat package no folding problem

  • November-28 2020 10:17:45

    arrivato molto veloce e sembra tutto ok


    Go to page

    recommendation for you