Kundenbewertungen

Eine Bewertung schreiben
  • Alle Bewertungen (199)
  • Bild (24)
  • Video (0)
  • Alle Sterne
    • Alle Sterne(199)
    • 5 Sterne(178)
    • 4 Sterne(6)
    • 3 Sterne(6)
    • 2 Sterne(2)
    • 1 Sterne(7)
Sortiere durch:
Zur Vorschau
  • Zur Vorschau
  • Am hilfreichsten
  • Die letzten
Bewertungen nur aus Ihrem Land (Germany)
|
Original zeigen

Ein Teil der Rezension wurde automatisch übersetzt.

  • 21/09/2016

    I've built and flown all of the Black Flyers: V1, V1.1 and V2. The V1 Is an excellent flyer, but the packaging means that some of the carbon can be broken in the post. The V1.1 and the V2 have improved packaging and a better wing fixing. The V1.1 is very similar to the V1 buthas an increased wing chord giving more wing area. Getting to the V2, it goes together well but, like the V1.1 it has a flat plate wing(s) which require great care in covering to avoid warping. It also means that the lack of wing section combined with the all flying tailplane means that the elevator is very sensitive and trim is critical. Both the V1.1 and V2 have a tendency to 'tuck' and dive into the ground. I feel that this is a design fault and they should have retained the cambered wing. On a value for money basis, you can't beat any of them. Weights with battery: V1 13.5 gm, V1.1 18 gm, V2 18 gm. All covered with tissue, not the supplied film.

    Kommentar (4)
    Original zeigen
  • 12/03/2020

    Sehr guter und einfach zu bauende Hallenflieger.Die größte Herausforderung sind die winzigen Bauteile insbesondere die Flächenbefestigungsschrauben.Das Flugverhalten des fertigen Fliegers ist tadellos.Mit 1S 160mAh bringt das Leichtgewicht gerade mal 23g auf die Waage.Der Motor hat auch ausreichend Leistung und es ist auch mal ein Looping auf kleinstem Radius möglich.Der Schwerpunkt paßt und es sind lange Flugzeiten machbar.

    Kommentar (4)
    Original zeigen
  • 24/12/2017

    This model went together following the downloaded instructions. As mentioned by others the hardest part was fixing the tiny self tapping screws. Get yourself a very small phillips screwdriver, fit a piece of heat shrink tube on the end to hold the screws while you screw them in. Do all this over a tray with soft cloth inside or you may lose them! I covered my model in crushed silver mylar - to save a little weight and make it look different from the others. It flew dead straight from my hand the first time that I flew it. It flies on half power. It circles tightly and loops easily. Great little model.

    Kommentar (2)
    Original zeigen
  • 09/09/2016

    Took about 3 hours to put together. Instructions are lacking of course, I ended up using the electronics from a crashed E-Flite SBach so I'm running its a little faster and heavier than it should be but flies pretty good for 19.99. Use a little super glue and this thing can take a crash for sure.

    Kommentar
    Original zeigen
  • 25/05/2020

    Ich erhalte meinen Artikel aber leider gibt es keine Anleitung, wie man das Flugzeug baut, Bitte lassen Sie mich wissen, wie zu tun Danke für Ihre Hilfe Grüße

    Kommentar
    Original zeigen
  • 23/07/2017

    Everything in the kit went together well. Used 3M spray on adhesive on the wings, tailplane and rudder CF assembies, then stretching the mylar covering on a flat board, and then dropping each assembly onto the mylar. Use a sharp craft knife and run around the outside of each assembly. Quite tricky getting the screws into the blocks that hold the wings in place, but got there in the end. Some more information or recommendations regarding ESC and receiver and servos would be good though

    Kommentar (1)
    Original zeigen
  • 12/05/2020

    Schwer zu bauen, sehr winzige Teile. Aber wenn fertig, sieht es erstaunlich.

    Kommentar
    Original zeigen
  • 12/06/2020

    FALSE, EIN STATUS, DER ARTIKEL I BOUGHT I CLEARLY SAGTE ALLE TEILE INCLUIDAS HAT NUR ZU BERGEBEN. GUTE FOLGUNG DER BESTELLUNG HAT IN EIN FALL OHNE ANWEISUNGEN, DIE NICHTS UND OHNE ELEKTRISCHES KOMPONENT FÜR IHREN HANDLE SPAREN DER PROPULSOR ELEKTRISCHE MOTOR. INSGESAMT, DASS ICH IM GLEICHEN ARTIKEL KAUFE (WENN I CLEARLY PONNED, MIT EVERYTHING ZU KOMMEN) UND SIE NICHT ALREADY EXISTIEREN. ICH HABE EINE ANDERE ANKÜNDIGUNG MIT DEM GLEICHEN ARTIKEL PONIENDO , die nicht mit diesen Teilen kommen, um Sie zu stellen, um es in 10 Tagen zu empfangen und immer zwei Monate ist für diesen STATUS EXPECTING. ZWEITE BAUEN CHINA UND CURIOSELY RETURNS CHINESISCHER ARTIKEL sind nicht verloren. INSGESAMT: DENUNCIEN ZUR NATIONALEN POLIZEI MIT ALLEN DATEN (DIE I OBVIOUSLY IN PANTALLAZOS HABEN) Ungefähr SINVERGÜENZAS.

    Kommentar (6)
    Original zeigen
  • 01/10/2016

    The plane arrived in good shape. I plan on using the parts as spares for the plane I have for indoor flying. Neat design, very delicate, but slow flyer for indoor use.

    Kommentar
    Original zeigen
  • 08/08/2020

    Wenn ich die Lieferung zu öffnen, fühlen sich sehr Puzzle, aber wenn ich auf yhe Motor und Propeller sehe ich erkannt, es sollte ein Flugzeug sein. Es ist wirklich kompakt. Hope kann die Montage abgeschlossen. Vielen Dank Verkäufer und Banggood.

    Kommentar
    Original zeigen
Show:

    Gesamt 0 Seiten

    Zur Seite gehen

    Sie interessieren sich vielleicht für:

    recommendation for you
    • US$6.80
    • US$59.99
    • US$80.99
    • US$11.49
    • US$25.29
    • US$169.99
    • US$43.69
    • US$15.97
    • US$179.99
    • US$17.31
    • US$124.99
    • US$120.00
    • US$73.99
    • US$109.00
    • US$89.99
    • US$83.99
    • US$84.99
    • US$119.99