Bestellt 4 Module, sie kamen OK nach 4 Wochen, jedes Modul in separatem antistatischen Beutel, zusammen in flexiblem Kunststoff-Umschlag. Keine Box. Kein Schaden. Getestet 1 Modul, funktioniert OK. ps: Wenn Sie von USB mit Strom versorgt werden, stellen Sie sicher, dass der USB-Anschluss genug Strom liefert, mein USB-Hub nicht genug Strom liefert, das Modul wurde neu gestartet (Brownout-Schutz). Onboard WIFI verbraucht viel Leistung nach ESP32 Foren.

Ordered 4 modules, they arrived OK after 4 weeks, each module in separate antistatic bag, together in flexible plastic envelop. No box. No damage. Tested 1 module, works OK. ps: When powered from USB, make sure USB port delivers enough power, my USB HUB did not deliver enough power, module kept rebooting (brownout protection). Running from PC USB port works fine. Onboard WIFI uses a lot of power according to ESP32 forums.

Bestellt 4 Module, sie kamen OK nach 4 Wochen, jedes Modul in separatem antistatischen Beutel, zusammen in flexiblem Kunststoff-Umschlag. Keine Box. Kein Schaden. Getestet 1 Modul, funktioniert OK. ps: Wenn Sie von USB mit Strom versorgt werden, stellen Sie sicher, dass der USB-Anschluss genug Strom liefert, mein USB-Hub nicht genug Strom liefert, das Modul wurde neu gestartet (Brownout-Schutz). Onboard WIFI verbraucht viel Leistung nach ESP32 Foren.

Received kit today immediately soldered pin headers and connected to Arduino IDE to check processor version and uploaded blink sketch as well as wifi_scan sketch. Nice good quality module. In Arduino IDE select board as “ESP32 Dev Module”. Chip on module is ESP32D0WDQ6 revision 1. You can see this in the sketch compile log.

Received kit today immediately soldered pin headers and connected to Arduino IDE to check processor version and uploaded blink sketch as well as wifi_scan sketch. Nice good quality module. In Arduino IDE select board as “ESP32 Dev Module”. Chip on module is ESP32D0WDQ6 revision 1. You can see this in the sketch compile log.

Received kit today immediately soldered pin headers and connected to Arduino IDE to check processor version and uploaded blink sketch as well as wifi_scan sketch. Nice good quality module. In Arduino IDE select board as “ESP32 Dev Module”. Chip on module is ESP32D0WDQ6 revision 1. You can see this in the sketch compile log.