Ein Teil der Rezension wurde automatisch übersetzt.
Tolles Produkt
I was able to mount this directly to my Ender 3 V2 stock mount using 2X 25MM M3 screws by tapping then drilling out paths in the top fin of the heat sync. I did this by removing the stock hot end and using it to center the screws and using spare M3 screws to tap the Heat sync. I then drilled out the paths using the tap as a guide. I was also able to transfer the Ender hot end and heat break as well. I didn't use any of the electronics. You will need to print a custom fan shroud. As for the parts, nothing premium here. All basic cheap parts but made with precision. I cant speak for the electronics. Side note, There is a custom PTFE insert called a throat I think. It would be great if Banggood sold spares. It is a 7mm to 4mm OD reducer that funnels the filaments into the hot end. The 2 in 1 out version also has one, but it's shorter.
Kam perfekt
Der Artikel kam sicher und pünktlich an, die Verpackung war etwas beschädigt, aber das Hotend war nicht beschädigt. die Qualität ist gut, obwohl ich das Gerät noch nicht installiert habe, aber keine Probleme erwarten.
Nicht versucht, noch aber aktualisiert, wenn ich es aber Qualität verwendet habe, die klug ist, es ist wirklich gut, besser als l gedacht, um ehrlich zu sein. Probieren Sie den Verkäufer aus...
sehr zu empfehlen
3rd class service by banggood . after 10 time conntrack 100 days to resive
Kann es kaum erwarten, meinen 3 in 1 Extruder zu benutzen! 😀😃
Perfekt kann das nicht beet
exelent