Nice switch, fits perfect in my Suzuki Vitara dashboard. I am using it to turn on my led light bar.

Nice switch, fits perfect in my Suzuki Vitara dashboard. I am using it to turn on my led light bar.

Nice switch, fits perfect in my Suzuki Vitara dashboard. I am using it to turn on my led light bar.

Very good switches to control led lights in your offroad vehicle! Simple connection and good quality.

Very good switches to control led lights in your offroad vehicle! Simple connection and good quality.

Very good switches to control led lights in your offroad vehicle! Simple connection and good quality.

Simple switch, easy to modify for your purpose. Switch has two blue LEDs each in series with a 4.6k resistor and a zener diode. This is the reason that the switch can accept the wide input voltage. One LED is lit by apply positive voltage to pin 6 and negative voltage to pin 7 - this is the instrument panel light located at the lower part of the switch. Applying a positive voltage source to pin 1 will light the upper LED only when the switch is in the on position. My use was for a 50V electric golf cart light install and by replacing the 4.6k SMD resistor with a 10k resistor gave me acceptable currents for the LED. Time will tell if this is truly acceptable.

Simple switch, easy to modify for your purpose. Switch has two blue LEDs each in series with a 4.6k resistor and a zener diode. This is the reason that the switch can accept the wide input voltage. One LED is lit by apply positive voltage to pin 6 and negative voltage to pin 7 - this is the instrument panel light located at the lower part of the switch. Applying a positive voltage source to pin 1 will light the upper LED only when the switch is in the on position. My use was for a 50V electric golf cart light install and by replacing the 4.6k SMD resistor with a 10k resistor gave me acceptable currents for the LED. Time will tell if this is truly acceptable.

Simple switch, easy to modify for your purpose. Switch has two blue LEDs each in series with a 4.6k resistor and a zener diode. This is the reason that the switch can accept the wide input voltage. One LED is lit by apply positive voltage to pin 6 and negative voltage to pin 7 - this is the instrument panel light located at the lower part of the switch. Applying a positive voltage source to pin 1 will light the upper LED only when the switch is in the on position. My use was for a 50V electric golf cart light install and by replacing the 4.6k SMD resistor with a 10k resistor gave me acceptable currents for the LED. Time will tell if this is truly acceptable.

I've ordered a lot I love them and so does my customers. can't get a better switch cheaper. thanks

I've ordered a lot I love them and so does my customers. can't get a better switch cheaper. thanks

I've ordered a lot I love them and so does my customers. can't get a better switch cheaper. thanks

fits nice and snug into my 4x4's dash clips and works perfectly for my needs, recommended for all 4x4 lighting switches.

fits nice and snug into my 4x4's dash clips and works perfectly for my needs, recommended for all 4x4 lighting switches.

fits nice and snug into my 4x4's dash clips and works perfectly for my needs, recommended for all 4x4 lighting switches.

Arbeit Scherz, wie sie sollen zu tun. Bisher kein Problem.

Work jest as they are supposed to do. So far not a problem.

Arbeit Scherz, wie sie sollen zu tun. Bisher kein Problem.

Erreicht

تم الوصول

Erreicht

Gut

Jó

Gut

zwei Monate

two months

zwei Monate

OK

ok

OK