Ein Teil der Rezension wurde automatisch übersetzt.
Gut verpackt, erhalten in gutem Zustand und angemessener Lieferzeit (19 Kalendertage ab Bestellung). Die Verkabelung ist etwas seltsam, weil der Druckschalter nicht richtig angeschlossen ist, aber es ist ein einfacher Mod, es zu beheben. Es funktioniert gut, wenn das erledigt ist.
Good condition arrived in safe and all parts is ok! Good value/quality ratio. Thank you! :)
The encoder is OK, but the switch is NOT brought out to any pins, which means soldering, no matter what you do. Since the 'C' pin is directly connected to the GND pin, you can cut the trace on the back between the two pins, and wire one side of the switch to the old GND pin, and then wire the other side of the switch to either 'C' (the new GND pin) or to VCC. Normally you'll want the switch to GND as most micros have internal pull-up resistors, and it's less to wire in later. I've added a schematic of the debounce filtering on the photos below for your convenience. If you still have too much bounce, you might want to add up to .1uF caps on top of the existing 22nF capacitors. You may not need it. Since the description doesn't mention it, the encoder has 20 detents / positions per 360 revolution. I can't do a PREVIEW, so hopefully the photo comes through readable.
Sehr zufrieden mit diesem Artikel!
Genau oder dass ich beabsichtigte
Wie beschrieben, in angemessener Zeit angekommen.
OK
OK
Ausgezeichnete Komponente, einfach zu verwenden mit Arduino.
Damit kann man nichts falsch machen.