300W 220V Isoliertes PTC-Luftheizelement Elektrische Heizung Fiebertabletten
Ein Teil der Rezension wurde automatisch übersetzt.
Great product real data in the description at least 80 degrees Celsius temperature! I recommend to everyone!!!
good product, well packaged, silent fan
I have bought this for my 3D printer chamber heater. The heater itself works flawlessly. If you connect a watt meter you can see power consumption at 300W at the start and as it heats up, you can see it getting lower upto 200 to 230W range. The lower range of power consumption depends on external control of my 3D printer cutting the power supply off. The AC fan included in it is very silent, absolutely no noise whatsoever. I even doubted if it's running at all. However the air flow and air pressure from the fan is really low. I'm sure it will work fine for other uses, but for my purpose which is to heat up a 3D printer chamber of 400mm x 400mm x 400mm, I think I will have to replace the included one with a better air flow fan.
used for chocolate tempering machine .... it is so awesome
Molto soddisfatto, ottimo prodotto!
Ich erwartete mehr Luftstrom. Also werde ich einen größeren Ventilator setzen. aber sehr schnelle Lieferung
Alles in einem Paket. Gibt gute Wärme.
exactly what it says it is in the description
I use it for a heating chamber, about 0.5x1x1 m foam box, Target Temperatur of 50°C is controlled by XH-W3001 Temperatur controller. Power can go up to 500 W, but may drop after a while to 350 W. In my application average power use was 150 W. With the integrated fan, Temperatur distribution inside my box is within 10°C.
Very good product