2S 3A Li-ion Lithium-Ionen-Batterieschutzladungsplatine 18650 BMS PCB-Ladegeräteplatine
Ein Teil der Rezension wurde automatisch übersetzt.
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
Schnell angekommen
sehr gut empfehlen 🤝🏿
gekauft, um externe Batterien sie ion für externe Modul r9m zu schützen. Die zu verlötenden Pads sind empfindlich. Bei 385° lösen sie sich ab und bewegen sich.
Schnelle Lieferung. Funktioniert gut
good quality, it's working, very small dimensions
sehr schnell angekommen, aber ich versuche es nicht, aber es sieht gut aus, wenn ich es versuche, werde ich mehr kommentieren
nice and small
O K Sehr gut.