10pcs Toroid Core Inductor Wire Wind Wound mah--100uH 6A RoHS cc
Ein Teil der Rezension wurde automatisch übersetzt.
These are wound on a YELLOW ferrite core of T50-6, which is active in transformation within 3 - 40 MHz. As a intended choke the active region is from DC to some 30 MHz. Wound with about 2.7 m enamelled CU-wire; some 157 turns. Tested 3 in my 10pcs batch, and they were all 98 - 102 µH. A good performer. Happy buyer.
Gut verpackt, erhalten in gutem Zustand und sehr schnelle Lieferzeit (7 Kalendertage ab Bestellung). Die meisten von ihnen getestet bei 100uF (Foto 2), aber ein paar getestet bei 90uF (Foto 3), das liegt im erwarteten Bereich, aber eine Erinnerung, nicht zu sehr auf Nennwerte zu verlassen. Ich finde diese nützlichen Gegenstände in meinem Hobby-Elektronik-Labor zu halten, vor allem, wenn ich mit DC-DC-Wandler für Solarenergie, etc. spiele.
They are almost all at 100uH which i was not expected.The unexpected was their size which turned out to be really small.
10pcs Hochstrom-Spulen für DC/DC.
Gutes Preis - Leistungs - Verhältnis
Inductance (for all ten) is well within specs (two are 97.8 μΗ, all the rest between 99,8 and 102.8 μΗ). To measure them I used a dedicated L/C meter, which has two scales, one for small inductance values, and one for large ones. My MASTECH MS8222H multimeter - which can also measure inductance – in the lower range of 0-2mH gives lower values compared to the ones obtained from the dedicated L/C meter, while for higher values both instruments give almost the same reading. Having checked both instruments with some small coils that had a label with their exact inductance value , I now trust the dedicated one. Exactly like other reviewers have said, for the 6A nominal current I was skeptical, so I decided to measure one of them. Well, the result was above my expectations. After 30 minutes at 3 Amperes DC, it had stabilized to 61 degrees Celcius, which I think is more than acceptable (see photo). I would push it a little further, if my power supply could give me more current, as I guess it can go up to 4 Amperes without problem. Concluding, 10 nice inductors for a very nice price. So, another 5 star. Thank you, Banggood.
Wire Diameter is only 0.55mm, you'd better not use it over 1.5A, but at this price, who cares?
Genau wie beschrieben und schnelle Lieferung! 👌
low price and good accurate 6A seems to be a bit optimistic !
They are nice but look small. Anyways, handy to have some of these. Great for making lc filters.