Selbstspannendes Schraubstock-Bohrfutter B16 mit MT2-B16 Spindel für Drehmaschine Bohrer
Ein Teil der Rezension wurde automatisch übersetzt.
Sehr guter Mandril...jeden Cent wert...Bearbeitung sehr gut gemacht
Produkt war erstklassig die Verpackung war nicht sehr gut, aber der Artikel war, dass gut gebaut es nicht mater
Fas Lieferung, gutes Produkt, sehr solide.
All good !
все хорошо, но диаметр шпинделя меньше чем диаметр посадочного гнезда патрона, примерно на 2 мм
Really pleased with this, it's nicely machined and the jaws close together perfectly so holding small drills will be no problem. The chuck feels very smooth when operating and is very nice to handle. Fairly quick delivery too !
Angekommen wie vereinbart, würde empfehlen!
1-16mm B16 Self Tighten Keyless Drill Chuck With MT2-B16 Arbor... Delivery time - 5 Days. Within 3 - 7 days advertised. Package arrived in good condition, contents correct. After wiping off the coating of preserving oil/grease with methylated spirits; I then assembled the chuck and taper shaft with a couple of light taps with a hammer. Inserted the chuck and taper into my drill and tapped it home with a wooden mallet. After checking it was in firmly I turned on the drill to check how it ran, no wobble/run out detected. I inserted a Drillpro 10mm drill bit into the chuck and drilled a hole in soft material (plastic wood) to allow any wobble/run out to show in the result. As shown in the pic the hole was 10mm. The pic shows how I confirmed the diameter of the hole. Good value for money for home workshop use; I can recommend this item.
I receved the chuck no arbour with it
so good I am thinking of ordering another one